Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Turn Off:
With the device on, press and hold the multifunction button (1)
for four seconds until you hear a voice say 'Power off'. The status
LED (3) will light up in red before the device turns off.
The first time the device is turned on, pairing is automatically started
– see 5.2 Bluetooth
5.2 Bluetooth
• First the two earphones must connect to one another.
• Ensure that both earphones are switched off.
• Press and hold the multifunction button (1) of both earphones
for approximately five seconds until the status LEDs (3) begin to
alternate between a red and blue light.
• The earphones pair with one another within about ten seconds
and can then be connected to a terminal device.
• If the two earphones cannot set up a connection within two
minutes, they will automatically switch off.
• If pairing was successful, you will hear a voice say 'Connected'.
Note
• When the device is turned on, the earphones automatically
connect to one another.
• The left earphone is always the master. The right earphone is
guided by the information of the master.
• Therefore, when connecting the headset to terminal devices in
future, you merely have to put the master into pairing mode.
The other earphone is automatically connected.
5.3 Bluetooth
• The earphones and the terminal device should be no further than
one metre apart. The shorter the distance, the better.
pairing – Headset.
®
pairing – Headset
®
pairing with terminal device
®
7
Advertenties
Inhoudsopgave
