Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTRUCTIONS FOR INSTALLATION
• Expel all air from the supply pipes/hoses before coupling
to the appliance.
• Do not turn the coupling tap when connecting it to the
gas supply.
• Avoid any pressure on the control tap and pipes.
• Check that all connections are gastight.
Positioning the logs
Distribute the vermiculite evenly over the front and back
burners. Make sure not to get too much vermiculite on
the ignition points of the front and back burners.
The separate logs can be seen in fig. 10, fig. 12 shows the
logs grouped in position.
Log 1: Against the notches on the back burner;
Log 2: Diagonally across log 1 with the knot side down;
Log 3: With the knot side in the corner on log 2;
Log 4: In the middle of the heater against the ridge on log
1, with the front against the teeth on the burner;
Log 5: Slanting backwards and on the front burner
support;
Log 6: In the left-hand corner on log 1 (there is a notch
on the back of log 1);
Log 7: On top of log 5, slanting up towards log 6;
Log 8: Diagonally across log 5 (must not lie on the burner
surface);
Log 9: With the knob in the burner and the front on the
teeth of the front burner;
Sprinkle the chips around the logs.
At the front, the chips can be laid on the burner teeth
(slanting upwards);
Do not cover completely, air must be able to circulate.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.
Dismantling / Fitting glass window frame
Remove the decorative panels, supplied separately,
(fig. 8a,b,c,).
Remove the eight self-tapping screws (fig. 8d) with the
spanner provided (fig. 9a).
Holding the handle (fig. 9b) lift the glass pane.
Lift the glass pane out of its hooks by lifting the top approx
1.5 cm and then tilting it forwards approx. 1.5 cm (fig. 9c).
Twist the window frame at the bottom of the heater in
the direction (fig. 9d).
Reassemble in reverse order.
For safety reasons a guard should be placed in
front of the fire at all times.
Remote control
Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.
Connecting the Receiver
The remote control system comprises a receiver and a
remote control, packed together in one box.The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of the box.
• Slide the brown plug of the cable onto the receiver circuit
board (fig. 10b).
• Connect the white plug to the connector on the gas
control valve.The different sized plugs correspond with
the connector.
• Open the lid.
• Insert 4 penlight batteries (type AA). Make sure they are
the right way round.
• Replace the lid.
• Connect the thermocouple wiring (Fig. 10b, arrows B)
• Connect the ignition
wiring (Fig. 10b, arrow C)
• Place the remote control
receiver in the tray on
the service flap.
• If you are using an
adaptor, connect it to
the unit
(Fig 10b, arrow A) and
plug the appliance in.
26
aerial
thermocouple
wiring
button B
high-voltage
transformer
button A
ignition wire
A
reset
B
C
fig. 10b
Advertenties
Hoofdstukken
Inhoudsopgave
