Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
eNet radiografische jaloezieactor 1-voudig mini
Configured venetian blind
position
Configured slat position
Behaviour after the end of the
disabling function
Manual saving of the scene
values
Priority, lock-out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Slat change-over time
Fabric-stretching time
Running time
Minimum change-over-time
82581433
J0082581433
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
no change
Last value
Down
up
Basic setting: No change
On, Off
Basic setting: On
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
0 ms ... 10 sec
300 ms ... 10 s
Basic setting: 0 ms / 300 ms
1 ... 600 sec
Basic setting: 120 s
300 ms ... 10 sec
Basic setting: 1 s
7/9
If the value "Configured positi-
on" is entered for the parame-
ter "Behaviour after voltage
return", then the blind/shutter
position set here is approa-
ched.
If the value "Configured positi-
on" is entered for the parame-
ter "Behaviour after voltage
return", then the slat position
set here is approached.
Behaviour of the output when
a block is removed.
Disables the saving of the cur-
rent Venetian blind position as
scene value in an actuator for
a command via a transmitter.
Specifies the priority for
recalling and removing a sce-
ne of type Lock-out protection
for the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Restraint for the
channel.
Specifies the priority for
recalling and removing a sce-
ne of type Wind alarm for the
channel.
Specifies the priority for
recalling and removing a sce-
ne of type Sun protection for
the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Twilight for the
channel.
Absolute time for changing-
over Venetian blind slats. The
fabric stretching time can also
be set here for the Awning
operating mode.
Absolute time which the
blind/shutter requires from the
top to the bottom end position.
The entry is essential if scene
or position movements are to
occur.
Minimum interruption time
when changing directions.
Increasing the minimum chan-
ge-over time will cause less
wear on the motors.
04.08.2016
Advertenties
Inhoudsopgave
