Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
placed at the minimally required fire-proof distance
from the stove to any wall at the back.
5.
Take precautionary measures against fire (see points
to 8 on page )
6.
Place the stove at the selected place.
7.
Remove the front and back plates from the base of
the stove.
8.
Level the stove (see illustration 0).
9.
Place the pipe between the stove and the outlet
channel. Connect a Ø 50 mm tube to the coupling
unit (the mouthpiece) in the straightest possible line
from the stove to the chimney. The tube must be
made of steel with a thickness of at least mm.
Please keep in mind that the tube will expand in the
length by about cm per meter, and verify that the
outlet is not jammed between the mouthpiece and
the ceiling.
0. Connect, if necessary, the combustion air supply
duct (minimum diameter: 00 mm). If the connec-
tion is in the back, you can use the cut-in piece
from the back plate in the base of the stove (see
photograph 0).
1. Base without back plate, with levelling feet
2. Base of the Solea, with cut-in piece
Repairs
Replacing the glass
Remember that the glass is sharp.
Remove the 4 screws and the spring plates in the inside
corners of the door.
Carefully remove the glass and any fragments.
Replacing the glass of Solea Madera
Close-up picture: 6 screws with head
Replacing the thermostat
• First remove the right-hand side panel. Slide the panel
upward, move it forward and slide the panel again
upward from the pins.
• Remove the knob on the front side.
• Remove the 6 screws as shown in the close-up
picture.
• Carefully remove the valve and replace the
thermostat.
Advertenties
Hoofdstukken
Inhoudsopgave
