Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
24
Using the detergent
A
B
30
20
Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the ap-
pliance. The appliance is in setting mode
when the display shows 2 horizontal status
bars. If the control panel does not show this
condition, press RESET.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Set a programme. if you want you can
set the applicable options
• The programme number flashes in the
display.
4. Close the appliance door. The pro-
gramme starts. The programme dura-
tion starts to decrease with steps of 1
minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay start button again and
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the display
and the delay indicator comes on.
3. Close the appliance door. The count-
down starts.
A
+
-
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press RESET. The display shows 2 hor-
izontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press RESET. The display shows 2 hor-
izontal status bars.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
The display shows 0 and the end indicator
comes on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
If you do not press the on/off button,
the AUTO OFF function automatically
deactivates the appliance a few mi-
nutes after the end of the programme.
This helps to decrease the energy con-
sumption,
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
