Advertenties
Step 4: Position the ballast
Remove the top hinge bolts B1 and place the
panel in a vertical position. Make sure that you
have some form of support in place or someo-
ne to hold the panel temporarily.
Step 5: Tighten hinge bolts B1
Attach the panel to the curved
supports again and tighten hinge
bolts B1.
Step 6: Finish fitting the cables
The loose cables can be secured to the edge of the panel
Using the cable clamps supplied.
Step 7: position the rows one behind each other
If a number of rows of panels are to be positioned one
behind the other, we advise that an optimal pitch measure of
2.20 metres is observed; this will avoid any unwanted
shadow. Optimal performance will be achieved if this pitch
measure is used. Based on sun angle of 15 degrees.
B1
B1
D
- 3 -
Detail B1
Tighten hinge bolts B1
tightly, with a tightening
moment of at least 9 Nm, until
there is no play.
Detail D
Pitch measure
Position the
ballast required.
See the
information on the
back of this
document.
Advertenties
