Advertenties
6)
System or systems of assessment and verification of constancy of perfor-
mance of the construction product as set out in Annex V:
System 3 and system 4
Niet van toepassing
7)
In case of the declaration of performance concerning a construction prod-
uct covered by a harmonised standard:
The notified laboratory "
tion of the product type on the basis of type testing under system 3
and issued test report
8)
Declared performance
Harmonized technical
specification
Essential characteristics
Fire safety
Reaction to fire
Distance to combustible
materials
Risk of burning fuel falling
out
Emission of combustion
products
Surface temperature
Electrical safety
Cleanability
Maximum water operat-
ing pressure
Flue gas temperature at
nominal heat output
Mechanical resistance (to
carry a chimney/flue)
Thermal output
Nominal heat output
Room heating output
Water heating output
Energy efficiency
9)
The performance of the product identified in points 1 and 2 is in conformity
with the declared performance in point 8.
This declaration of performance is issued under the sole responsibility of the
manufacturer identified in point 4.
Signed for and on behalf of the manufacturer by:
RYDE TOON zaakvoerder, director
(name and function)
Brugge, 20 januari 2015
(place and date of issue)
K.V.B.G.-A.R.G.B
." performed the determina-
2014/0078 File N° H/2013/0025
EN 13240:2001/A2:2004/AC:2007
Performance
A1
Minimum distances, in mm
rear = 200
sides = 200
ceiling = 150
front = 800
floor if wood : do protect it
Pass
CO[0.038 %]
Pass
Pass
Pass
/
T [280 °C]
NPD
6,62 kW
/
/
η
[77
%]
System 4 for electric components only
to be given by the manufacturer
NOTE The number of the notified body
is the number assigned by the Commis-
sion following the notification procedure.
to be given by the manufacturer accord-
ing to the number of the test report given
by the notified laboratory
If the old standard just gives 1 value this
has to be put at rear, sides, ceiling or the
relevant value has to be taken from the
NB-report. For front the relevant value
has to be taken from the NB-report.
If ceiling is not relevant (and therefore
not tested) leave the issue out here.
* For appliances without hot water sup-
ply, set a "-" in front of bar
As there is no test in the standard NPD
should generally be used.
*For appliances without hot water supply,
set a "-" in front of kW. In this case con-
sequently the room heating output and
the nominal heating output shall be
identical.
no comment
(signature)
Advertenties
