Advertenties
013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 06.06.19
Operating Instructions
Testing probe
Button
High intensity LED
Screw
Open
Close
ATTENTION:
With the exception of the batteries, never attempt to
remove any components from the device.
Do not use the device if the screw has been removed.
Tighten the screw completely (clockwise).
Prior to Use
Self Test
that the device is functioning correctly.
If this does not happen, stop using the device.
When the LED starts to weaken, the batteries need to
be replaced!
Voltage Test (Alternating Current)
the test tip (1) contacts one of the poles of the socket
to be checked, the socket conducts voltage.
Note: as the presence of voltage at the socket is
measured by means of an antenna in the multi-tester,
the LED will flash upon contact with every single pole
of the socket and signal voltage.
8
Before each use of the device, a self
test must be performed in order to
assure correct function. Just touch
the probe with one hand and the
screw on the device with the other.
The blinking of the LED indicates
(1) direct voltage test
(70-250 VAC)
ATTENTION!
The multi-tester is NOT a commer-
cially available phase tester.
If the LED (3) starts flashing when
MT 6 S/2
Advertenties
