Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Replacing battery
Attention! Before opening the battery case cover of the meter, make sure that
all measurement lines are removed and the device is turned off to prevent the
hazard of an electric shock.
• If this symbol
immediately to prevent possible hazardous situations.
• Loosen the screw of the battery case cover on the back of the device and
remove the case cover.
• Replace the empty battery with a 9 V block battery.
• Close the battery case with the cover again and screw it down.
Replacing fuses
Attention! Before opening the battery case cover of the meter, make sure that
all measurement lines are removed and the device is turned off to prevent the
hazard of an electric shock. Only use fuses with the required values: F1 FF 400 mA
H 600 V, F2 FF 10 A H 600 V.
• Fuses only need to be replaced rarely. A blasting of a fuse is often a
consequence to a faulty operation.
• Loosen the screw of the battery case cover and remove the battery.
• Remove the green rubber cover of the device. Loosen the four screws of the
casing and remove it.
• Replace the blown fuse with a new fuse with the appropriate capacity.
• Close the casing again and screw it down. Place the device back in the green
rubber cover again. Afterwards screw firm the battery case cover after placing
the battery.
Replacing measurement lines
Attention! A warranty is only given when the included measurement lines are
used according to the safety standards. If required, they are to be replaced with
the help of the same model or with measurement lines of the same appropriate
capacity.
• Required capacity of the measurement lines: 600 V 10 A.
• You have to remove the measurement lines if the insulation is damaged.
36 | Englisch
appears on the display, the battery should be changed
ProfiScale MULTI PS 7455
For cl
aggr
can s
Dirt a
clean
meas
the p
T
help
devic
r
unda
Dear
Pleas
r
r
Printing
Advertenties
Inhoudsopgave
