Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CAUTION! Risk of burn injuries! To
prevent burns, verify the product is switched off
and has cooled down for at least 15 minutes
before touching it . The product can become
very hot .
The accessible surface, especially heat shrink,
is very hot when the lamp is operating .
For HG11410, HG11410-FR: The
power plug
can only be connected
18 ]
[
with a corresponding socket with the same
ingress protection (IPX4) in order to keep the
protective degree against dust/water .
For HG11410-BS: Power plug for indoor
use only .
The product can be used on a flat, stable
surface, e .g . floor or table .
The product must not be used as a hand lamp .
m
WARNING! Risk of fire! Fit the
product so that it is at least 1 m away
from the material to be illuminated .
Excessive heat can result in a fire .
The product is only suited for use with the
built-in LED control gear .
The product continues to draw a small amount
of power even if the product is off as long
as the product is connected to the supply
mains . To switch the product off completely,
disconnect the power plug
outlet .
Luminaries shall not be connected after each
other .
This is not a portable lamp . Disconnect the
power plug
from the socket-outlet before
18 ]
[
moving the tripod .
from the socket-
18 ]
[
˜ Before installation
NOTE: Remove all packaging materials from
the product .
The product may be placed on the provided
tripod
and then be positioned in the
12 ]
[
desired location .
Rotate the tripod locking screw
clockwise to loosen the tripod
Adjust the tripod
[
12 ]
Rotate the tripod locking screw
to fix the tripod in its position (Fig . M) .
Use and operate the product on a stable
surface without any angle .
Fully extend the tripod
stability of the product .
m
CAUTION! Note the position of your hands
whilst opening or closing the tripod
pinching your fingers (Fig . M) .
˜ Installation
Unscrew the pre-installed fastening material
from the baseplate
This includes:
–
Handle fixing screws
[
1 ]
–
Handle spring washers
2 ]
[
–
Flat washers (handle)
[
3 ]
–
Spotlight fixing screws
[
4 ]
–
Flat washers
5 ]
[
–
Spring washers
6 ]
[
Attaching the handle
Fig . B
Fasten the handle
8 ]
[
To do so, use the following fastening materials:
–
Handle fixing screws
[
1 ]
–
Handle spring washers
2 ]
[
–
Flat washers (handle)
[
3 ]
Turn the handle fixing screws
until fully tightened .
anti-
14 ]
[
(Fig . M) .
12 ]
[
to the desired position .
clockwise
14 ]
[
and check the
12 ]
[
. Risk of
[
12 ]
(Fig . A) .
7 ]
[
to the baseplate
.
7 ]
[
clockwise
[
1 ]
GB/IE/NI
9
Advertenties
Hoofdstukken
Inhoudsopgave
