Advertenties
For round cells:
Intelligent "PERFECT 7 CHARGING" function (SEE PAGE 2):
1.
Capacity quick test: Residual capacity is determined
before charging begins and displayed for 5 seconds
2.
Gentle pre-charging: Weak or deeply discharged battery is
pre-charged with lower current if necessary
3.
Battery analysis: Battery behavior is analyzed and
evaluated to determine whether it is still reliably usable or
defective
4.
Quick charge: Battery is charged at maximum current
5.
IQ switch-off: Intelligent monitoring of the battery for
reliable charging and multiple protection against
overcharging
6.
Top-off charge: Ensures that the battery is gently charged
to 100% capacity
7.
Trickle charge: Battery is kept in a fully charged state by
means of charging pulses
For 9V E-Block:
Capacity quick test, defective battery detection, Time-controlled
charging
OPERATION
§ Connect the charger with the included USB cable.
§ Connect the USB cable to any suitable USB port (e.g. power
supply, PC, Power bank...).
§ Insert the battery into the charging slot with the correct polarity
(see engraving in the charging slot).
§ The product displays the charge status of the battery for 5 seconds
and then automatically starts the charging process.
§ As soon as a battery is fully charged, the charger switch to trickle
charge.
§ You can now remove the fully charged battery.
§ After all batteries have been removed, disconnect the product from
the power supply
Deutsch |
English
| Français | Español | Português | Svenska
14
Italiano | Nederlands | Dansk | Suomi | Norsk
LED INDICATION
Capacity indication (for the first 5s
after insertion)
Charging
Error
Full / trickle charge
Pause (*1)
(*1) If the connected USB device does not supply enough current (re-
commended min. 2.1A), the device will pause a charging slot. You can
still charge your batteries without any problems, but the charging
process takes longer due to this pause.
TROUBLESHOOTING
Problem
Possible cause
No LED indication
- No connection to
USB power source
- USB power supply
defective
Battery is not recog-
- Battery inserted
nized
with reverse
polarity
LED is flashing orange
- Battery slot pau-
ses, as the current
of the USB power
source is too low to
charge all batteries
at the same time
CARE AND MAINTENANCE
Cleaning
Disconnect the power supply to the product and remove all batteries
before cleaning.
Only use a soft, dry or slightly damp cloth for cleaning (if necessary, add a
little mild washing-up liquid). Never use abrasives or solvents for cleaning.
Deutsch |
English
| Français | Español | Português | Svenska
Italiano | Nederlands | Dansk | Suomi | Norsk
Red
Orange
Green
<25%
25-75%
>75%
On
Flashing
On
Flashing
Resolution
- Check the con-
nection
- Use a different
USB power supply
- Insert the battery
with the correct
polarity
- Use USB power
source with a mini-
mum of 2.1A output
current
- Or accept the lon-
ger charging time
15
Advertenties
