VONROC CD501DC Vertaling Van De Oorspronkelijke Gebruiksaanwijzing pagina 5
Verberg thumbnails
Zie ook voor CD501DC:
- Vertaling van de oorspronkelijke gebruiksaanwijzing (25 pagina's)
Advertenties
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR DRILLS
AND SCREW DRIVERS
Drill safety warnings
a) Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
b) Hold the power tool by insulated gripping surfa
ces, when performing an operation where the
cutting accessory may contact hidden wiring.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock.
c) Brace the tool properly before use. This tool
produces a high output torque and without
properly bracing the tool during operation, loss
of control may occur resulting in personal injury.
SAFETY INSTRUCTIONS WHEN USING LONG
DRILL BITS
a) Never operate at higher speed than the maxi
mum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece,
resulting in personal injury.
b) Always start drilling at low speed and with the
bit tip in contact with the workpiece. At higher
speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece,
resulting in personal injury.
c) Apply pressure only in direct line with the bit
and do not apply excessive pressure. Bits can
bend causing breakage or loss of control, resul-
ting in personal injury.
WWW.VONROC.COM
2. MACHINE INFORMATION
Intended use
This cordless drill is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Chuck capacity
Torque settings
No load speed
Position 1:
Position 2:
Weight
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screwdriving without impact)
Hand-arm vibration a
h,D
(Drilling into metal)
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other batte -
ries could cause serious injury or damage the tool.
CD801AA
20V, 2Ah Lithium-Ion
CD803AA
20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA
Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
EN
CD501DC
20V
13 mm
21+ Drill mode
0-400 /min
0-1500 /min
1.15 kg
89.9 dB(A), K=3dB(A)
99.9 dB(A), K=3dB(A)
0.700 m/s
2
K=1.5 m/s
2
1.746 m/s
K=1.5 m/s
2
2
5
Advertenties
