Advertenties
Furno 550 18V
9. Application
Always read the safety information included in this manual before
using the Heat Gun.
Hands-free operation
Press the locking button (6) while holding down
Press the locking button (6) while holding down
the trigger (5) to activate continuous operation.
the trigger (5) to activate continuous operation.
Place the heat gun on a flat surface.
Place the heat gun on a flat surface.
To switch the heat gun off again, briefly actuate
To switch the heat gun off again, briefly actuate
the trigger (3).
the trigger (3).
Stripping Paint
Always protect glass when working near windows.
Do not use the Heat Gun on surfaces that can be damaged by heat, such
as vinyl-coated paneling, vinyl-coated siding or vinyl-coated window
frames.
When removing paint from window frames, the Heat Gun will soften
the putty. Be careful not to gouge the putty with the scraper. The putty
will firm up after it cools.
Do not use the Heat Gun on insulating laminated window glass such as
Thermopane. The glass edge expansion may break the edge seal.
The Heat Gun heats up the surface and causes the paint to soften, at which time it can be
scraped off easily without damaging the surface. Some paints may soften even though
they do not blister; some may become rubbery, and some may require higher heat.
When working with several layers of paint, it speeds up the scraping process to heat the
surface thoroughly, all the way to the wood. Then all the layers can be scraped at one time.
A soft wire brush may be the best tool to use for very intricate surfaces. Mineral paints
and finishes, such as cement paint and porcelain, do not soften with heat, so using a
heating tool will not work for paint removal.
The best method of paint removal
Move the Heat Gun slowly and steadily forward at an angle to the surface, pointing the
nozzle in the direction of motion. This allows you to scrape safely outside the hot air
stream and keeps the scraper and the scraped surface cooler.
EN
5
6
21
Advertenties
