Advertenties
All manuals and user guides at all-guides.com
Cycle number
K1 condition
K2 condition
Life time and cycle # zeroing
Configuration parameter readings
Configuration parameter setting
Note that the new input value are put in effect only at the next
STOP/START of the pump.
If PRINT is selected and a printer is connected on RS 232 line, an
unidirectional communication is established and every minute the
data are sent to the printer, even if the pump is not running.
The set of data available are:
Pump speed KRPM
Pump temperatures
Pump current A
Pump power W
K1 condition
K2 condition
The controller is factory-set to HOST.
Confirm the selection by pressing the PUMP CURRENT push-
button.
In this way you enter into an operating phase named "Monitor
Relay Programming" described in the following paragraph.
Turbo-V 2000HT Controller User Manual / 87-900-913-01 (O)
Technical Information
Use
279/306
17
Advertenties
Hoofdstukken
