Inhoudsopgave
Advertenties
7. OPERATING INSTRUCTIONS
Removing or Installing Battery Pack
Charging the Battery Pack
7. When you charge a new battery pack or a battery pack which has not been used for a long
period, it may not accept a full charge. This is a normal condition and does not indicate a
problem. You can recharge the battery pack fully after discharging it completely a couple of
times.
9. Please remove the battery from the unplugged charger for storage.
The LED Light on the Charger
Battery Pack LED Indication Function (Optional)
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity
status. The fuel gauge green LED will indicate when the "SW" button is momentarily pressed.
1. Always switch off the machine before insertion or removal of the
battery pack.
2. To remove the battery pack, push the button on the battery pack and
pull the tool unit from the battery pack in the direction.
3. To insert the battery pack, align the tool unit slides with the battery
pack sliding groove and push the tool unit into place.
The tool unit can be slide into battery pack in two directions.
4. Do not force the battery pack in sliding it into tool unit. If the battery
pack does not slide in easily, it is not being inserted correctly.
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
on the charger.
3. Push the battery pack into place and make sure the red light on the
charger is "ON". The battery pack is now starting the charging cycle.
battery pack is now ready for use.
5. Your new battery pack is not charged. You need to charge it before
use.
battery pack is inserted into the charger correctly, the red light will
come on and charging will begin.
Battery Low (Red light stays illuminated)
Battery charged 100% (Green light stays illuminated)
Battery Pack malfunction (Red and Green lights stay illuminated)
•
•
8
Advertenties
Inhoudsopgave
