Inhoudsopgave
Advertenties
*
Anti-condensation strip
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before the first washing, completely fill the salt
dispenser with water and add only then approximately 1
kg of salt (see chapter entitled Rinse aid and refined salt).
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value (see chapter
entitled Rinse aid and refined salt). - After the salt has been
poured into the machine, the LOW SALT indicator light*
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.
Technical data
width 59.5 cm
Dimensions
height 82 cm
depth 57 cm
Capacity
14 standard place-settings
Water supply
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure
7,25 – 145 psi
Power supply voltage
See appliance data plate
Total absorbed power
See appliance data plate
Fuse
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EC (WEEE)
All manuals and user guides at all-guides.com
The machine has a buzzer/set of tones
dishwasher model
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
Transportation
Unload all crockery from the dishwasher and secure moving
parts.
All water remaining inside the appliance should be drained
as follows:
make sure that the water tap is open and select the ECO cycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
the ON/OFF button until you hear a beep and the indicator lights
switch off. Wait for approximately 5 minutes before uninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of
freezing, or if you intend to be away for extended periods of time
(e.g. holiday home) , empty the appliance completely.
- Carry out the process used to drain all water remaining inside
the appliance (see Transportation).
- Disconnect the appliance from the electricity supply and shut
off the water tap.
- Leave the appliance door ajar.
- When you return, run a cycle while the dishwasher is empty.
*
Only available in selected models.
) to inform the user that a command has
(depending on the dishwasher model)
(depending on the
EN
.
21
Advertenties
Hoofdstukken
Inhoudsopgave
