Advertenties
8. Assembly / Before commissioning
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
8.1 Machine stand assembly (fig. 3 - 6)
• Secure the two wheels using a washer (15) and a
split pin (16) each (fig. 3).
• Secure the right-hand side panel (5a) and the left-
hand side panel (5b) using two fillister head screws
(18) and two hexagon nuts (19) (fig. 4).
• Now fit the intermediate part (13) using a total of four
fillister head screws (17) (fig. 5).
• Place the housing cpl. with engine (3) on the ma-
chine stand and fix it with a total of eight fillister head
screws (17) (fig. 6).
8.2 Fitting the dust bag (fig. 7)
• Attach the dust bag (10) to the lower air outlet using
the clamp fitting (11) (fig. 7).
8.3 Fitting the filter bag (fig. 8)
• Insert the retaining rod (1) into the housing cpl. with
engine (3) and hook in the filter bag (2) (fig. 7).
8.4 Fitting the suction hose (Fig. 9 + 10)
• Attach the suction hose (6) to the nozzle on the
housing cpl. with engine (3) and fix it with a hose
clamp (14) (fig. 9).
• Attach the hose coupling (8) to the other end of the
suction hose (6) using a hose clamp (14) (fig. 10).
9.
Start-up
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
9.1 Switching on/off, Fig. 1
• To switch on, set the ON/OFF switch (4) to position
"I".
• To switch the device off again, set the ON/OFF
switch (4) to position "0".
22 | GB
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high start-
ing current (from 3000 watts)!
Connection type Y
If the mains connection cable of this device is damaged,
it must be replaced by the manufacturer, their service
department or a similarly qualified person to avoid dan-
gers.
www.scheppach.com
Advertenties
