Avoid damage to the insulation during installation. DO NOT pierce or otherwise compromise wire's or socket's outer covering,
jacket or sheathing.
WARNING: When using outdoor use portable luminaires, basic safety precautions should always be followed to reduce the risk of
fire, electric shock, and personal injury, including the following:
-
Use only two-wire outdoor extension cords that have two-prong plugs and receptacles that accept the light string's plug.
-
Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s) or outlet(s) to be used for the wet
location portable light string luminaire. Receptacles are available having built-in GFCI protection and are
able to be used for this measure of safety.
-
Use only with an extension cord for outdoor use such as an extension cord
IMPORTANT: The maximum distance to the receptacle is determined by the length of the cord provided and the appropriate
extension cord if used.
PRODUCT INFORMATION:
220-240V~, 50/60Hz, 10 x E27 excluded;
Class II, IP64
INSTALLATION:
1. The light string kits are compatible with E27 bulb (not included) x 10 pieces.
2. Before plugging in the light string, fill each socket with a bulb. The formulated PVC socket is tall and the contact points are at
the base of the socket. When lamping, the bulb will have to be turned slowly but firmly to stretch the PVC around the bulb.
Ambient temperatures around 65°- 95°F (18° - 35°C) are ideal since the PVC will be more pliable.
3. After each socket is lamped, plug the light string into an AC outlet and be sure each light bulb lights. If not, take note those
one(s) didn't light, unplug and carefully turn the unlighted bulb(s) until they make contact with the power contacts at the base of
the socket. Repeat until all bulbs light up, then proceed with installation.
SUSPENDING LIGHT STRINGS:
Light sockets must be suspended so that bulbs are facing down only. DO NOT MOUNT THE LIGHT STRINGS WITH SOCKETS FACING
UPWARD!
1. Secure light string to supporting hardware (eyebolts, brackets, etc., not provided) using cable ties (not included). See Figure 1.
2. Cover the unused female receptacle at the last light string with electrical tape to preclude the entrance of water.
3. For spans exceeding 5 meters, use properly rated cable support system and cable ties (neither are provided with the light string)
and follow local codes for suspended structures and loads.
ES
INFORMACIÓN SOBRE SEGURIDAD
IMPORTANTE, GUÁRDELA PARA FUTURAS CONSULTAS: LEA DETENIDAMENTE ANTES DEL PRIMER USO
No conecte la cadena al suministro mientras esté en el embalaje.
No retire ni inserte lámparas mientras la cadena esté conectada al suministro.
Asegúrese de que todos los portalámparas están equipados con una lámpara.
Sustituya inmediatamente las lámparas averiadas por lámparas del mismo tipo que las suministradas o del tipo especificado por el
fabricante.
ADVERTENCIA: ESTA CADENA DE LUCES NO DEBE UTILIZARSE SIN QUE TODAS LAS JUNTAS ESTÉN COLOCADAS.
ADVERTENCIA: RIESGO DE DESCARGA ELÉCTRICA SI LAS LÁMPARAS ESTÁN ROTAS O FALTAN. NO UTILICE.
El cable flexible externo o cordón de esta luminaria no puede ser sustituido; si el cordón está dañado, la luminaria deberá ser
destruida.
Estos productos pueden representar un posible peligro de descarga o incendio.
3