Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
COMPONENTS (SEE PAGE 2)
Water outlet
1
Water inlet
2
Suction cups
3
Drainage hose
4
Pump filter
5
USE PRECAUTIONS
• The PUMP IT UP water-pump is reserved for private and domestic use only; mostly for drai-
nage, disposal and water transfer. The pump is made to stay inside the tank of a domestic air
dehumidifier fitted with continuous drainage function.
• Only use the hose provided with your pump. Using another hose could damage the wa-
ter-pump or it could not be adapted.
• Do not try to extend the hose: the water-pump is designed for lifting the water to a maximum
of 3 meter.
• Do not leave the water pump in stagnant water while the appliance is switched off.
OPERATING INSTRUCTIONS
1. Connect the hose to the pump's water outlet. Make sure it is well connected. Then connect
the female connector of the electric cable with the male connector. This junction has to be
placed outside of the tank and outside of the dehumidifier.
2. Place the pump at the bottom of the air dehumidifier tank. It is perfectly hermetic and de-
signed to be immersed under water up to 50 cm deep.
3. Ensure that the drainage hose is running onto a water outlet installation (sink, drain, toilets
etc.) after going through the outlet of the appliance.
4. Plug the electric cable into a safe wall socket, after going through the outlet of the ap-
pliance. Your water pump is now ready to be used.
When the water level reaches the sensor, the pump automatically switches on and water is
drained away. When the water level is below the sensor, the pump automatically switches off.
PUMP IN OPERATING SITUATION (SEE PAGE 3)
Air dehumidifier fitted with continuous
1
drainage function
Tank
2
Pump
3
Male and female electrical junction
4
10
Water level sensor
6
Female connector
7
Male connector
8
AC adaptor
9
Electric supply
5
Hose and electric cable outlet
6
Drainage hose
7
To water outlet
8
MAINTENANCE
• Make sure the unit is turned off and unplugged before handling.
• Do not use corrosive, abrasive or flammable products to clean the unit.
CLEANING THE TANK: We recommend you to clean regularly with white vinegar the tank of your
appliance in which you are using the pump to prevent the formation of lime scale.
CLEANING FILTER : Clean the filter every 3 to 6 months of use. Open the pump and clean the filter
with clean soapy water and then rinse.
STOCKAGE : To prevent the growth of bacteria or viruses, make sure that the entire unit is com-
pletely dry.
FAQ
Circumstance
Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
The product
electrical system of your
does not work
house.
> The tank is empty.
> The tank is not properly
placed.
> Filter might be obstructed
The pump does
or dirty.
not evacuate
> The hose might be
water
obstructed or bent.
> Water sensor has a contact
The pump does
failure.
not stop
> Filter might be obstructed
or dirty.
Water disposal
flow is weak
> The water is dirty.
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Fill the tank.
> Push and place the tank properly.
> Clean the filter with clear water
and gentle soap. Rinse well.
> Unclog and/or unfold the hose.
> Unplug and remove the pump. Dry
and then clean the water sensor
with a dry cloth.
> Clean the filter with clear water
and gentle soap. Rinse well.
> Clean the pump and tank with
clear water and gentle soap.
Rinse well.
11
Advertenties
Inhoudsopgave
