Advertenties
4. The LED for the relevant current battery charge level flashes during the charging process. As
soon as the Deep Tissue Massager is fully charged, all 3 LEDs will light up permanently. The
battery will last for approx. 5 hours of operation when fully charged. If, during operation, the
left LED of the battery charge level display 3 starts to flash, the device must be charged, as
otherwise it will automatically switch off.
5.2 Selecting/changing the attachment
Choose the suitable attachment before you begin massaging.
To change an attachment, proceed as follows:
1. Pull the existing attachment horizontally off the Deep Tissue Massager
2. Slide your desired attachment firmly into the Deep Tissue Massager until you feel it click se-
curely into place
5.3 Switching the device on/selecting the vibration level
Note
The Deep Tissue Massager comes with an automatic switch-off function. This means that the
Deep Tissue Massager automatically switches off after a period of use of 10 minutes.
1. Slide the ON/OFF switch
on the battery charge level display
2. Press the ON/OFF button
play
starts to light up. The massage starts at intensity level 1.
1
3. To change between the fi ve intensity levels, briefl y press the ON/OFF button
Intensity level 1:
Intensity level 2:
Intensity level 3:
Intensity level 4:
Intensity level 5:
4. You can switch off the device at any time during use by pressing and holding the ON/OFF
button (approx. 2 seconds). If you press the ON/OFF button
level, the device will switch off. The device is in standby operation.
5. Slide the ON/OFF switch
plication. The device is completely switched off.
Note: If the device stops during application, this may be a result of excessive exertion of
pressure. Therefore, ensure that you do not exert too much pressure while applying the de-
vice.
6. CLEANING AND MAINTENANCE
Cleaning
WARNING
• Switch off the device each time before cleaning.
• Do not clean the device in the dishwasher.
• Only clean the device with a slightly dampened cloth and a non-abrasive detergent. For hygi-
enic cleaning, clean the attachments
agent.
• Clean the device only in the manner indicated. Under no circumstances must any liquid be
allowed to enter the device.
.
C
on the underside of the handle 4 to the "ON" position. The LEDs
6
3
to switch the device on. The left LED of the intensity level dis-
2
approx. 1800 rpm/30 Hz
approx. 2100 rpm/35 Hz
approx. 2400 rpm/40 Hz
approx. 2700 rpm/45 Hz
approx. 3000 rpm/50 Hz
on the underside of the handle
6
will begin to light up.
/
/
/
with water and a non-abrasive cleaning
7
8
9
10
19
.
B
again on the fifth intensity
2
to the „OFF" position after ap-
4
:
2
Advertenties
