Advertenties
Using the Product as Intended
The 60983 decoder is designed for converting Märklin/Trix
H0 locomotives with high-effi ciency propulsion and an NEM
652 interface connector.
!
Not suitable for motors with fi eld-wound coils.
Contents as Delivered
1 decoder with an NEM interface connector plug
1 Adhesive pad (only 60982)
Installation instructions
Warranty card
Tools also needed for the installation procedure include:
regular and cross-point screwdrivers, tweezers, and solder-
ing station with a maximum soldering temperature of up to
30 watts / 400˚Celsius / 572˚Fahrenheit with a fi ne tip, solder-
ing fl ux for electronics (0.5 - 1 mm / 0.02" – 0.04" diameter),
de-soldering braid or a de-soldering pump.
Safety Notes
• WARNING! Sharp edges and points required for operation.
• Do wiring and assembly work only on a voltage-free or
grounded work mat. Failure to do this can lead to danger-
ous static charge from your body and to damage to the
components.
• Operate the decoder only with the authorized voltage
(see technical data).
There is a danger of burning yourself when working
with a soldering station.
20
Technical Information
• Continuous current load at the motor output
• Current load at the light outputs
• Current load at AUX 1 – AUX 4 each
• Current load at AUX + lights (total)
• Current load for motor and AUX 5/6
• Maximum total load
• Maximum voltage
• Short circuit and overload protection at the outputs lights
front (LV), lights rear (LH), AUX 1 – AUX 4 and at the motor
outputs.
≤ 1.1 amps
≤ 250 milliamps
≤ 250 milliamps
≤ 300 milliamps
≤ 1.1 amps
≤ 1.6 amps
≤ 40 volts
Advertenties
Hoofdstukken
