Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
risks will remain. Due to its con-
struction and build, this electric tool
may present the following hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the ap-
pliance for longer periods of
time or if the unit is not held or
maintained properly.
Warning! During operation,
this electric tool generates
an electromagnetic field
which, under certain cir-
cumstances, may impair the
functionality of active or pas-
sive medical implants. To re-
duce the risk of serious or le-
thal injuries, we recommend
that persons with medical
implants consult their doctor
and the manufacturer of their
medical implant before oper-
ating the machine.
Assembling instructions
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
To put together the equipment:
1. Turn the black twist lock (24)
on the motor head (10) until the
notches match up to those in the
green casing. Lock open symbol
.
2. When plugging in the telescopic
tube (9) be aware of the different
plastic pin thicknesses on the
tube. Only one position is possi-
ble.
3. Plug the end of the telescopic
tube (9) all the way into opening
on the motor head (10). If the
position is correct, the cross-
head screw on the pipe is no
longer visible.
4. To lock, turn the twist lock (24)
approx.45º clockwise. Lock closed
symbol
.
To put on the protective cover:
1. Place the protective cover (14)
on the motor head (10) and
screw it down with the 3 Phillips
screws.
To put on the auxiliary handle:
2. Pull the ends of the auxiliary
handle (5) to extend the han-
dle and slide it over the handle
holder (22).
3. Screw down the screw (23) in
the auxiliary handle (5).
Mounting the trimming unit:
4. Slip the cutting disc (12) onto the
axle. There is only one mounting
position. Screw the cutting disc
(12) to the axle. Mind the left-
hand thread. Please ensure that
the screws are properly tightened.
Place the cutting insert (13) on
the pin (23) on the cutting disk
(12) and pull out the insert until it
snaps in.
Spare cutting inserts are kept in
the box (4) on the auxiliary handle
(5).
GB
23
Advertenties
Hoofdstukken
Inhoudsopgave
