Advertenties
Trimming at fences and foundations
IMPORTANT!
Do not touch fixed structures - danger of
kickback!
1. Guide the machine slowly and carefully, without
allowing the cutting line to strike against obsta-
cles.
Trimming around tree trunks
1. Carefully and slowly guide the machine around
tree trunks so that the cutting line does not
touch the tree bark.
2. Mow from left to right around tree trunks.
3. Strike the grass and weeds with the tip of the
line, and tilt the spool head forward slightly.
Trimming along stone walls, foundations and
trees results in increased line wear.
Mowing
1. Slant the spool head at a 30 degree angle to
the right.
2. Turn the hand grip to the required position.
IMPORTANT!
Remove foreign bodies from the working
area.
Danger of injury/damage to property due to
objects being thrown out.
Maintenance and care
CAUTION!
Danger from electrical current!
Before all maintenance and care jobs,
disconnect the machine from the mains and
secure it to prevent it from being switched
back on.
After use, disconnect the mains plug and check
„
the machine for damage.
Keep the machine out of reach of children and
„
unauthorised persons.
Electrical malfunctions are only allowed to be
„
rectified by authorised specialist workshops.
18
Never use the machine if the blade of the line
„
cutter is missing or damaged.
Always keep the guard plate, spool head and
„
motor clear of mowing residues.
Do not spray the machine with water! Penetra-
„
ting water can lead to malfunctions.
Do not get the machine wet or expose it to mois-
„
ture.
Regularly check the machine is in good working
„
order.
Do not use any cleaning agents or solvents.
„
They can cause irreparable damage to the ma-
chine.
Cleaning the guard plate
1. Switch off the machine.
2. Use a screwdriver or a similar tool to remove
mowing residues carefully.
Clean the guard plate regularly in order to
avoid the stem tube overheating.
Changing the spool (Fig. 5)
1. Brace spool head (2) to loosen fastening screw
(2) clockwise.
2. Unscrew and remove fastening screw.
3. Pull the spool head off the drive shaft.
4. Remove spool (1) from the spool head.
5. Remove dirt and grass residues.
6. Thread the ends of the cutting lines from the
new spool into the openings provided for them
in the spool head.
7. Insert the spool into the spool head. Make sure
that the cutting lines do not become jammed,
and pull them out of the spool by about 9 cm.
8. Push the complete spool head onto the drive
shaft and tighten anticlockwise with the faste-
ning screw.
9. Hold the spool head firmly and tighten,
Changing the line knife
1. Unscrew and remove the two screws arranged
on the inside edge of the guard plate and remo-
ve the old line knife.
Translation of the original operating instructions
Advertenties
Hoofdstukken
