NO.
Name
QTY
57291ASS16
57289ASS16
57294ASS16
57294ASS16
57282ASS16
57282ASS16
57282ASS16
57282ASS16
57282ASS16
57282ASS16
57313ASS16
57313ASS16
57313ASS16
57313ASS16
57277ASS16
57277ASS16
01
Liner
1
57277ASS16
57277ASS16
57319ASS16
57319ASS16
57319ASS16
57273ASS16
57273ASS16
57273ASS16
57266ASS16
57266ASS16
57266ASS16
57271ASS16
57271ASS16
57265ASS16
57265ASS16
57265ASS16
CHOOSE THE CORRECT LOCATION
NOTE: The pool must be set up on a completely flat and level surface. Please do not install
the pool if the surface is inclined or sloped.
Correct conditions to set up the pool:
pool is installed, moreover the location must be flat and must be cleared of all objects and debris
including stones and twigs.
pool.
NOTE: Position the pool near an adequate drainage system to deal with overflow or to discharge
the pool.
Incorrect conditions to set up the pool:
personal property and will void the warranty and prevent any service claims.
utility pipes, lines or cables of any kind.
or tar are not suitable.
therefore we recommend removing all grass from the selected pool location.
or liner.
NOTE: Check with your local city council for by-laws relating to fencing, barriers, lighting and
safety requirements and ensure you comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for instructions.
NOTE: The ladder must match the pool size and should be used only for entering and exiting the
pool. It is forbidden to exceed the permitted payload of the ladder. Check regularly if the ladder is
properly assembled.
Installation
Bestway Inflatables will not be responsible for damage caused to the pool due to mishandling or
failure to follow these instructions.
ATTENTION: Do not use a high pressure air hose or over-inflate the top ring, it should be slightly
stiff to the touch.
NOTE: Do not use extension power cords to power your pump.
ATTENTION: Do not drag the pool on the ground, this can damage the pool.
NOTE: The base or bottom of the pool should be laid out properly (flat without wrinkles).
NOTE: Hot temperatures cause air to expand the ring and may cause damage. Leave some room
for expansion.
Please see FAQ's for additional information.
ATTENTION: Do not leave pool unattended while filling with water
Pool walls will rise as you fill with water.
In times of heavy rainfall you may need to empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on any side to ensure the
pool is level.
0°
IMPORTANT: If pool is not level, drain water and re-level ground by digging out . Never attempt to
move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If your pool has any bulge or uneven
side, then the pool is not level, the sides may burst and the water may discharge suddenly causing
serious personal injury and/or damage to property.
Part NO.
Remark
#57291
5.49m x 1.22m (18'x48")
4.57m x 1.22m (15'x48")
#57289
#57294
4.57m x 1.07m (15'x42")
#57311
4.57m x 1.07m (15'x42")
#57281
4.57m x 91cm (15'x36")
#57280
4.57m x 91cm (15'x36")
#57121
4.57m x 91cm (15'x36")
#57293
4.57m x 91cm (15'x36")
#57282
4.57m x 91cm (15'x36")
#57310
4.57m x 91cm (15'x36")
4.57m x 84cm (15'x33")
#57318
#57316
4.57m x 84cm (15'x33")
#57315
4.57m x 84cm (15'x33")
#57313
4.57m x 84cm (15'x33")
#57277
3.66m x 91cm (12'x36")
#57263
3.66m x 91cm (12'x36")
#57278
3.66m x 91cm (12'x36")
#57309
3.66m x 91cm (12'x36")
#57323
3.96m x 84cm (13'x33")
3.96m x 84cm (13'x33")
#57321
#57319
3.96m x 84cm (13'x33")
#57275
3.66m x 76cm (12'x30")
#57274
3.66m x 76cm (12'x30")
#57273
3.66m x 76cm (12'x30")
#57270
3.05m x 76cm (10'x30")
#57269
3.05m x 76cm (10'x30")
#57266
3.05m x 76cm (10'x30")
#57272
2.74m x 76cm (9'x30")
2.74m x 76cm (9'x30")
#57271
#57268
2.44m x 66cm (8'x26")
#57267
2.44m x 66cm (8'x26")
#57265
2.44m x 66cm (8'x26")
Mud, sand, soft / loose soil
NOTE: Drawings for illustration purposes only.May not reflect actual product. Not to scale.
1
3
5
For 5.49m x 1.22m (18' x 48") pools, please refer to the connection valve installation on following
page.
Connection Valve Assembly
For 5.49m x 1.22m (18' x 48") pool model (See Fig.1)
Fig.1
A
#08
#06
NOTE: If you want to connect other pool cleaning kits to the pool through the connection valve,
use a Phillips screwdriver to disassemble the Debris Screen from the Connector. (See Fig.2)
Fig. 2
4
2
4
#05
6
80%
B
#07
#06
S-S-003432