Airfusion QUEST II Installation Instructions
WOBBLE:
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE
MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING IT
WOULD CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW CENTIMETRES IS QUITE
ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH FIX THE MOUNTING
BRACKET AND DOWN ROD ARE SECURE.
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour "breaking-in" period, most noises associated with
a new fan disappear during this time. The manufacturer's warranty covers actual faults that may develop
and NOT minor complaints such as hearing the motor run – All electric motors are audible to some extent.
CARE AND CLEANING:
•
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
•
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create
the possibility of an electrical shock.
•
The motor has a permanently lubricated ball bearing so there is no need to oil
NOTE: Always turn off the power at the mains switch before attempting to clean your fan.
FAN models
48" FANS
52" FANS
IN AUSTRALIA / NEW ZEALAND – Please refer to the separated WARRANTY STATEMENT.
IN EUROPE – If you are a European customer please contact the retail outlet where the fan was
purchased for warranty service.
12 | P a g e
AFTER INSTALLATION
TECHNICAL INFORMATION
Rated Voltage
Rated power (motor)
220-240VAC
220-240VAC
WARRANTY INFORMATION
Rated power for light
65W
1 X MAX. 60W E27
75W
1 X MAX. 60W E27