Inhoudsopgave
Advertenties
7. Close the hood.
5.4
Fitting a diamond cutting disc
1. Fit the clamping flange on to the arbor.
2. Place the first diamond cutting disc on the clamping flange.
Observe the specified direction of rotation.
3. Screw on the Kwick-Lock nut until it is seated against the cutting disc.
4. Close the hood.
5.5
Setting depth
1. Release the locking screw.
2. Push the back panel to the desired position.
▶ The scale shows the group.
3. Firmly tighten the locking screw.
5.6
Plunge function
1. Position the carriage plate on the work.
2. Switch on the tool.
3. Guide the cutting disc into the work.
You can disable the plunge function with the locking screw.
5.7
Fitting the side handle
▶ Fit the side handle on the desired side.
6
Operation
6.1
Wall and corner accessibility
1. Press the locking catch.
2. Open the front clip more than 180 °.
6.2
Marks for cut positioning
Mark 1 indicates the position of the inner cutting disc or single disc, as applicable.
Mark 2 indicates the maximum slitting width (max. position of the second disc).
6.3
Removing the accessory tool
1. Open the hood. → page 8
2. Open the clamping nut.
3. Remove the diamond cutting disc.
4. Remove the spacer rings.
5. Remove the diamond cutting disc.
6. Use the pin wrench to release the adapter.
7. Press the catch on the angle grinder.
8. Turn the hood radially until it can be removed from the tool.
6.4
Breaking out the fillet
▶ Break out the fillet.
*267722*
5
6
7
8
9
267722
English
9
Advertenties
Inhoudsopgave
