Inhoudsopgave
Advertenties
TTM NoXygen
EN
Installation, operating and maintenance instructions
Installation
Pipe connection
•
TTM NoXygen
is fitted with a ½" internally threaded connection.
®
The connection is made with a steel-braided hose to system's return
conduit in front of the pump and exchanger.
•
Connection to the system should always be made at the top of the
pipework. When connecting on the bottom of the pipe, TTM MAG 54
or TTM MAG 76 filters should be installed before TTM NoXygen
on the incoming pipe. Installation of a filter on the incoming pipework
is recommended for all other connections.
•
The pipe to the degasser must be fitted with shut-off valves. The
distance between connection points shall be at least 300 mm
(Fig. 1 och 2).
Drip Tray
The drip tray's ½" connection is connected to the floor drain (Fig. 3).
Floor installation
For floor mounting, the TTM NoXygen
horizontal (Fig. 4).
Electrical Connection
TTM NoXygen
is connected by plugging in the wall plug to an earthed
®
socket 1-230 V, 50 Hz Alternatively, it can be connected to a fixed
earthed connection with a circuit breaker. The electrical unit should be
equipped with a residual current device.
Connection to External Monitoring (DUC)
The TTM NoXygen
C650 can be integrated in the building automation
®
system with MODBUS RTU via RS485. The switching pin is mounted
externally on the right side of the device (Fig. 5).
Fig. 5
4
C650
®
Main flow V
Circulation water
is placed on its feet so that it is
®
OBS!
Existing cables in the coupling slot
should not be moved or
disconnected.
Slöjdaregatan 1 | 393 66 Kalmar | Sweden | Tel. + 46 480-41 77 40 | info@ttmenergi.se | www.ttmenergi.se
Fig. 1
Main flow V
Circulation water
®
≥300
Fig. 2.
Fig. 3
Fig. 4
Adjust the adjusting screws at the floor
Installation.
≥300
High gas
Low gas
TTM Energiprodukter AB
For latest updates visit www.ttmenergi.se.
2023-11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
