Inhoudsopgave
Advertenties
EN
Adjusting the locking pin of
the return stroke limiter
When using short pressing
attachments (compatibility 2), the
return stroke limiter can save you
time.
Prerequisite
–
Pressing attachment is not inserted.
▶
Tap the start button. During the
pressing procedure, pull out the
locking pin and rotate by 90°.
✓ The locking pin fastens into the
groove.
Result
✓ The roller drive moves back until it
reaches the set locking pin. The
pressing tool is ready for operation.
In order to reset the return stroke limiter,
tap the start button, pull out the locking pin
and rotate back by 90°.
34
Pressing with Geberit
pressing attachments
WARNING
Risk of injury caused by flying
fragments
▶ Wear protective goggles and
a protective helmet.
WARNING
Risk of injury caused by the
use of incorrect pressing
attachments
▶ Only use pressing
attachments that correspond
to the diameter of the
pressfittings to be
processed.
WARNING
Risk of fire from heat build-up
▶ Allow the pressing tool to
cool down for at least
30 minutes after 30 minutes
of continuous operation.
▶ Do not place or store the hot
pressing tool near easily
flammable materials.
The pressing procedure can be
cancelled at any time. → See
Cancelling the pressing procedure.
To improve ease of use, the pressing
head of the pressing tool can be
turned to any position up to 180°
before pressing. The pressing head
can only be rotated before the
pressing procedure.
90071994454716171 © 12-2023
968.240.00.0(04)
Advertenties
Inhoudsopgave
