Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Appliance description
6.
Appliance description
Standard delivery
WUT illustration
1 Swivelling spout with aerator and non-return valve to pre-
vent dripping
2 Tap body
3 Gasket
4 Spring sleeve
5 Mating fitting (spanner size 13)
6 WUT: Moulded plastic fitting for kitchen sink installation
7 Butterfly valve
8 Fitting G 3/8
7.
Installation
f Secure the tap with gasket, spring sleeve and mating fitting.
f
f WUT: Use the moulded plastic fitting to secure the tap in the
f
kitchen sink.
f Fasten the spout to the tap body.
f
10
| WST | WUT
All manuals and user guides at all-guides.com
7.1
1
2
3
4
5
6
7
8
f Connect the short connection hose to the angle valve of the
f
f Connect the long connection hose marked blue to the "Cold
f
f Connect the long connection hose marked red to the "DHW
f
8.
f Thoroughly flush the cold water supply line.
f
f Filling the water heater: Turn the temperature adjusting tap
f
f Wait until water flows from the outlet, then switch on the
f
Water connection
Material damage
!
With non-pressurised water heaters, observe the max-
imum permissible flow rate when the tap is fully open
(see chapter "Specification / Data table").
f If the flow rate is exceeded, install the supplied but-
f
terfly valve in the cold water line.
Material damage
!
The water heater can leak.
f Never subject the water heater to water pressure.
f
f Do not interchange the connection hoses.
f
Note
Ensure that the connection hoses are not kinked or under
tension during installation.
cold water supply line.
water inlet" connection on the water heater.
outlet" connection on the water heater.
Commissioning
head to max. temperature (fully anti-clockwise) and open the
draw-off valve.
water heater.
www.stiebel-eltron.com
Advertenties
Hoofdstukken
Inhoudsopgave
