Advertenties
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
CONNECTIONS
1. FILTER SWITCH: In passive mode, a single
amplifier can be used to power all drivers inside
the loudspeaker. The full frequency range is put
into the loudspeaker and the loudspeakers' internal
crossover separates the frequencies, delivering the
right frequencies to the right driver. In the example
of a 2-way passive loudspeaker, this means that
the single amplifier is powering both the HF
compression driver and the LF transducer. The
internal crossover takes care of both the frequency
and power separation.
In bi-amp mode, two power amplifiers can be used.
This gives you the advantage of being able to
select the best power amplifier specifications for
each driver inside the loudspeaker. In a bi-amp
configuration, an external crossover is used to
separate the frequencies and this splits the signal
to the dedicated LF amplifier and the HF amplifier.
This way, each amplifier is only working on the
given frequency range and, in turn, is powering the
corresponding driver inside the loudspeaker.
2. INPUT: Receive the signal coming from an
external amplifier.
(PASSIVE +1/-1 connected; +2 -2 not connected)
(BI-AMP +1/-1 LF, +2-2 HF)
3. OUTPUT: Direct link for connecting a second
speaker in parallel.
(PASSIVE +1-1 connected; +2 -2 not connected)
(BI-AMP +1/-1 LF, +2-2 HF)
3
Advertenties
