CAUTION! Before each use, check that there is no gap between the parents' mattress and the side wall of the cot.
WARNING: Use of the product is only permitted with beds and/or mattresses that have straight sides. The use
of the product next to beds and/or round mattresses and water mattresses is prohibited.
PLAYPEN INSTALLATION
In order to use the playpen function, the product must be properly prepared. To do this:
1.
To unfold the playpen, adjust the maximum height of the frame using the height adjustment lever (fig. 8).
Make sure the metal tabs are inside the holes. A clicking sound indicates that the elements are mounted
correctly.
2.
Remove the stiffening element of the opening side (fig. 16).
3.
Then unfasten the zip on both sides and let the fabric fall down with the mattress (fig. 17).
4.
To ensure that the playpen is sufficiently stable, attach it to the stabilisation bar and the base support with
Velcro straps mounted underneath the mattress (there are special fastening holes in the floor) (fig. 17A, 18).
CAUTION! Make sure the playpen is set at maximum height and the legs at the base are fully extended.
INSTRUCTIONS FOR COT REMOVAL
1.
Remove the mattress from the cot.
2.
Unzip the zips in the cot covers (fig. 19).
3.
Release and remove the handrail connecting tube (fig. 11).
4.
Unfasten the Velcro connecting the cover to the drop side (fig.16), remove the stiffening element of the
opening side,
5.
Unzip the zip and then remove the cover.
6.
Remove the upper long handrail by pressing the release button on both sides (A, fig. 9).
7.
Remove the accessory basket by detaching it from the frame.
8.
Pull the stabilisation bar and remove it from the side frames.
9.
Remove the support by unscrewing the screws with an Allen key and removing it from the side frames
of the cot.
10.
Remove the side frames and then assemble the frame. The height should be set at position "1".
CONVERSION OF THE COT INTO A TODDLER COT/SOFA
1.
Remove the mattress from the cot.
2.
Unzip the zips in the cot covers (fig. 19).
3.
Release and remove the handrail connecting tube (fig. 11).
4.
Unzip the zip and then remove the cover.
5.
Remove the accessory basket by detaching it from the frame.
6.
Remove the stabilisation bar by pressing the release button on both sides (A, fig. 2).
7.
Next, stretch the upper long handrail and frame bracket by pushing in the tab (fig. 20) and pulling. A clicking
sound indicates that the stroller is unfolded correctly.
8.
Stretch the stabilisation bar by pushing in the tab (fig.20) and place it in the empty holes on either side of
the side frames (fig.2). A clicking sound indicates that the elements are mounted correctly.
9.
Insert the side support into the joints of the upper long handrail (fig. 22). A clicking sound indicates that
the safety bar is engaged correctly.
‑ 19 ‑
EN