Inhoudsopgave
Advertenties
_MWE-900.book Seite 49 Freitag, 12. Januar 2007 4:53 16
All manuals and user guides at all-guides.com
MagicWatch MWE900
8
Using the parking aid
The sensors are activated automatically when you engage the reverse gear
with the ignition on or the engine running. An activation signal sounds (two
short beeps).
As soon as there is an obstacle within the detection range, a repeated signal
tone sounds and the warning LED on the loudspeaker flashes.
As you reverse, the sequence of beeps changes according to the zone the
obstacle is in, thus indicating the distance (chapter "Performing a functional
test" on page 48).
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
Caution!
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are manoeu-
vring:
The device first shows an obstacle while you manoeuvre, and the
beeps speed up as normal (e.g. from slow to medium). Suddenly
the beeping sound slows down, or no obstacle is shown at all.
This means that the original obstacle is in the blind spot of the sen-
sors (construction-related characteristic), and it is possible to hit it.
8.1
Setting the system
You can adapt the system to your vehicle, e.g. the volume or the stop zone.
The settings are made at the control electronics.
Caution!
Incorrect settings can impair the safe operation.
The control electronics have the following control elements:
No. in
fig. j, page 10
1
2, 3
Description
Display
Buttons for setting the system
Using the parking aid
49
Advertenties
Hoofdstukken
Inhoudsopgave
