Inhoudsopgave
Advertenties
EN
Refrigerating tips:
•
Condensation and ice will form with frequent and prolonged opening of the doors.
•
Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and internal/external condensation. If external condensation occurs wipe
the surface down with a cloth.
•
Excessive ice will result in longer running times that will increase energy consumption and increase
the deterioration of components.
•
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency,
replace gasket.
•
Do not obstruct fans and do not exceed max load lines, as doing so will impact air distribution and
increase energy usage.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
The appliance is
leaking water
The appliance is
unusually loud
6
UA013_ML_A5_v3_20240927.indb 6
UA013_ML_A5_v3_20240927.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the evaporator
Condenser blocked with dust
Door not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is not properly
levelled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The drip tray is overflowing
Loose nut/screw
The appliance has not been
installed in a level or stable
position
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the Condenser
Check door is shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
2024/9/27 14:01
2024/9/27 14:01
Advertenties
Inhoudsopgave
