Inhoudsopgave
Advertenties
11. Remove the water tank and drain the water. Clean the water tank with a
cloth and, if necessary, with a mild detergent and then thoroughly dry the
water tank inside and outside.
12. Fill the water tank with water again if you want to continue to operate the
unit, otherwise replace the empty water tank.
13. Proceed in reverse order to replace the water tank.
14. Be sure to insert the pump properly and secure it with the locking clip.
Attention: For hygienic reasons replace the water in the water reservoir
once a day to avoid bacterial growth.
Do not, under any circumstances, pour water directly into the appliance!
COOLING PACKS
1.
If need be you can freeze the two provided cooling packs in the freezer com-
partment and then likewise place them in the water reservoir to obtain an
even greater cooling effect. We recommend that you always use one cooling
pack and store the other cooling pack in the freezer compartment for the
next day.
2.
The water reservoir must be filled with water beforehand.
3.
The cooling packs contain a special granulate, which ensures that the coo-
ling capacity is higher.
4.
Open the screw cap of the cooling pack.
5.
Fill the cooling pack with water to the mark.
6.
Close the cooling pack carefully and place it in a freezer compartment for
a few hours.
Copyright UNOLD AG | www.unold.de
7. Place the cooling pack in the water
reservoir. Bear in mind that the cooling
pack causes the water level to increase.
The water level must not rise above the
Max mark, under any circumstances.
Close the water reservoir as described in
the preceding section.
8. Attention: At extremely high tempera-
tures condensation can form on the water
reservoir and drip onto the floor. There-
fore, protect the floor appropriately.
27
Advertenties
Inhoudsopgave
