Intended Use; Technical Data - Hilti TE 3000-AVR Originele Handleiding
Verberg thumbnails
Zie ook voor TE 3000-AVR:
- Handleiding (126 pagina's) ,
- Bedieningshandleiding (29 pagina's) ,
- Gebruiksaanwijzing (23 pagina's)
Inhoudsopgave
Advertenties
Power tool locating pin
)
3.3
Intended use
The product described is a hand-held electric breaker with 28 mm hex chuck. It is designed for chiseling
work on concrete, masonry and asphalt. Excavation and compacting are further possible applications.
▶ Operation is permissible only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.4
Possible misuse
This product is not suitable for working on hazardous materials.
This product is not suitable for working in a damp environment.
3.5
Service indicator
The breaker is equipped with a service indicator LED.
Status
The service indicator lights red.
Service indicator flashes red.
"Ready for operation" indicator flashes green.
"Ready for operation" indicator shows green.
Bring the product to Hilti Service in good time. This will help to ensure that it's always ready for use.
3.6
Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.7
Items supplied
Electric breaker, operating instructions, grease.
The transport trolley is available as an accessory.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4
Technical data
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
16
English
Carrying handle
+
Meaning
•
End of service interval – servicing is due. Bring
the product to Hilti Service.
The product is faulty. Bring the product to Hilti
•
Service.
•
Temporary fault. Wait 10 seconds for the
flashing to stop.
•
If the flashing does not stop within 10 seconds,
unplug the supply cord from the power supply
and wait for 2 minutes.
•
If the flashing does not stop, bring the product
to Hilti Service.
•
The overheating prevention cut-out has been
activated.
•
Allow the product to cool down.
Product is ready for use.
2228667
*2228667*
Advertenties
Inhoudsopgave
