Inhoudsopgave
Advertenties
Setup
Preparing the Input Cover
The input cover is designed for three different wiring scenarios. To change the configuration of the
input cover to support your wiring scenario, cut along the perforation on the rubber conduit. Use one
1/2-inch to 1/2-inch threaded coupling and two 3/8-inch trade size conduit fittings for 1/2-inch knockouts
(see diagram to the right).
CAUTION: Do not use the wide open wiring scenario when installing the input cover with a
flexible conduit.
Note: It is the installer's responsibility to seal against water ingress into the Euroblock connector. Use
outdoor or marine-grade silicone to seal all wiring connections to ensure a tight seal.
Note: Flexible conduits and couplings must be UL Listed, suitable for the application, and installed in
accordance with the local authorities having jurisdiction.
Single In
Wiring the Loudspeaker
Wire Gauge
The FreeSpace FS2P loudspeaker is designed to work with 18 AWG (0.8 mm
Connection Diagrams
Expose six millimeters (1/4 inch) of
bare wire to attach to the terminals.
Note: The loudspeaker is not rated
for use with a rigid conduit. The
loudspeaker is suitable for a flexible
conduit or wiring connection only.
Note: Wiring method must be in
accordance with:
In Canada, CSA C22.1, Canadian
Electrical Code, Part I, Safety
Standard for Electrical Installations,
Section 32;
In the United States, The National
Electrical Code, NFPA 70, and the
National Fire Alarm and Signaling
Code, NFPA 72.
Loudspeaker Settings
4 • English
In and Out
70/100V
* Factory default
Transformer Tap Setting
Set tap by turning. Use a flat head screwdriver.
Wide Open
) to 14 AWG (2.1 mm
) size wire only.
2
2
70V
1W
2W
4W
2W
4W
8W
100V
** NC: No Connection (do not use)
BoseProfessional.com
16Ω
8W
16W*
16W
NC**
FreeSpace FS2P • Installation Guide
16Ώ
Advertenties
Inhoudsopgave
