Inhoudsopgave
Advertenties
!
The ISOFIX connectors must be attached and locked onto the
-1
ISOFIX anchor points.
6
!
The load leg must be installed correctly with green indicator.
6. Push the infant carrier module down into the base
enhanced infant child restraint is secure, the enhanced infant child
restraint indicator shows green.
!
Pull up on the infant carrier module to be sure it is securely latched
into the base.
7. To release the infant carrier, pull the infant carrier up
squeezing the infant carrier release button.
8. To remove the base, press the secondary lock button
-2
then the button
on the ISOFIX connectors before removing the
10
base from the vehicle seat.
9. Press the ISOFIX releasing button to fold the ISOFIX.
Height Adjustment
for Head Support and Shoulder Harnesses
see images
-
12
15
Check that Shoulder Harness Straps are set at the proper height.
Please choose the proper pair of shoulder harness slots according to
the child's height.
!
The bottom of headrest must be level with the highest point of
child's shoulder, it is shown as
13
!
If the Shoulder Harness Straps are not at proper height, the child
might be ejected from the enhanced infant child restraint if there is a
crash.
Squeeze the head support adjustment lever
push down the head support until it snaps into one of the 7 positions.
The head support positions are shown as
13
, if the
7
8
-2
9
-1
9
-1
10
10
11
, but not above the shoulder line.
12
, meanwhile pull up or
14
15
Securing Child
in the enhanced Infant Child Restraint
-2
6
see images
Note
1. Infant insert is for children's protection. Children whose height
is under 60cm are suitable to use the infant insert.
2. Before using the insert, please add the foam wedge.
while
3. After the child is placed in the seat, check if the shoulder
harnesses are set to the correct height.
first and
1. While pressing the harness adjustment button, pull completely the
two shoulder harnesses of the enhanced infant child restraint.
2. Unlock the buckle of the harnesses by pressing the red button.
3. Place child into the infant carrier module and lock the buckle.
4. Tighten the shoulder harnesses by pulling adjustment webbing.
Detaching Canopy and Seat Pad
see images
To re-assemble the soft goods, reverse the aforementioned steps.
-
16
21
Remove the body portion of the infant insert
when the infant's shoulders no longer fit
comfortably.
-
22
27
16
17
18
&
19
20
21
14
Advertenties
Inhoudsopgave
