Inhoudsopgave
Advertenties
Connecting electrical power to the video splitter
When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 9, page 6).
Protect every through-hole made in the bodywork against water penetration, e.g. by
using a cable with a sealant and by spraying the cable and the cable sleeve with seal-
ant.
NOTE
I
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.2
Connecting the controller
➤ Connect this connection (fig. 2 1, page 3) to the controller.
➤ Connect this connection (fig. 2 2, page 3) to the monitor.
➤ Connect the cable set (fig. 1 3, page 3) to the plug of this connection (fig. 2 3,
page 3).
7.3
Connecting the cable set
The cable set features the following connections:
No. in
Explanation
fig. 0, page 6
1
Connections for camera 1 – 4, 6-pin, protected from jets of water
2
12 V connection +, red
3
Earth connection –, black
4
Control input for reversing light (camera 1), green
5
Control input for camera 2, white
6
Control input for camera 3, blue
7
Control input for camera 4, brown
➤ Connect the camera connections (fig. 0 1, page 6) to the cameras.
➤ Connect the red cable (fig. 0 2, page 6) to the positive wire (+) of the vehicle.
➤ Connect the black cable (fig. 0 3, page 6) to the earth wire (–) or to earth (bodywork).
➤ Connect the green cable (fig. 0 4, page 6) to the positive wire (+) of the reversing light
(camera 1).
➤ Connect the white cable (fig. 0 5, page 6) to the control signal for camera 2.
➤ Connect the blue cable (fig. 0 6, page 6) to the control signal for camera 3.
➤ Connect the brown cable (fig. 0 7, page 6) to the control signal for camera 4.
28
All manuals and user guides at all-guides.com
VS400
EN
Advertenties
Hoofdstukken
Inhoudsopgave
