Inhoudsopgave
Advertenties
COMMISSIONING THE DEVICE
1.
To operate the device, insert the power plug (A) into the power socket.
2. In order to set the desired temperature, slide the temperature control (D) to the desired level (0 = OFF,
1 = low temperature, 2 = medium temperature 3 = maximum temperature). On the display screen (C),
the set level is now shown.
3. The device switches off automatically after approx. 90 minutes.
4. In order to restart the device after the operating time has expired, you must set the temperature control (D)
to "0". After 5 seconds, you can start it by setting the temperature again.
5. After use, please disconnect the power plug from the power socket.
TROUBLESHOOTING
Problem
The device is not connected to
the power supply system
The device does not
The device is not switched on
warm up.
The device is defective
CARE INSTRUCTIONS
•
Before cleaning the device, the power plug must be disconnected from the power socket.
•
Inner layer:
it can be washed by hand or in the washing machine at 30° C using a mild detergent.
•
Foot warmer:
The device can be washed only by hand.
•
Do not iron the device.
•
Please do not use any detergents containing chlorine.
•
Do not dry clean the device.
•
The device and its cover cannot be tumble dried.
•
Do no use any high-pressure cleaners.
•
Make sure that the controller does not come into contact with any liquids. Liquids may result in damage.
•
Never use the device while it is wet or damp. The device must not be switched on while it is drying.
•
Let the device air dry. Do not use any auxiliary means (such as clothes pegs) to hang it up to dry. This may
damage the cables inside.
Storage and regular inspection
•
Do not crumple the device. Carefully fold the product to store it.
•
Store the device in a dry place when it is not in use.
•
Allow the device to cool before you fold or roll it up.
•
Inspect the device and the power cable for possible signs of wear or damage at regular intervals.
•
If there are such signs, if the appliance has been misused or does not work, return it ro the supplier before
switching it on again.
•
Please do not use any chemical moth protection.
•
Do not place any heavy objects on the device during storage, as this may damage the electrical wiring.
•
In the event of malfunction or defects, send the device to the manufacturer.
Cause
Insert the power plug into the power
socket and switch on the device
Switch on the device
Send the device to the manufacturer
Troubleshooting
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI
Advertenties
Inhoudsopgave
