Download Inhoudsopgave Inhoud Print deze pagina

Repair; Caution! Pay Attention To The Surrounding Temperature; Warning! Pay Attention To Safety During The Connection; Power Supply - Medion AKOYA P54160 Handleiding

Inhoudsopgave

Advertenties

Repair

 Leave the repair of your TFT monitor exclusively to qualified specialist personnel.
 Please contact our authorised Service Partners exclusively in the case of a necessary repair.

Caution! Pay attention to the surrounding temperature!

 The TFT monitor can be operated at a surrounding temperature from 0° C to +35° C and at a relative
ambient moisture level of < 80% (non-condensing).
 The TFT monitor can be stored at -20° C to +60° C when it has been turned off.
Danger! Pay attention to the following:
Wait to bring the device into operation until it has reached the surrounding temperature,
after the TFT monitor has been transported.
Moisture, which can cause an electrical short-circuit, can form within the TFT monitor in
the case of wide variations in temperature or moisture.

Warning! Pay attention to safety during the connection!

Power supply

Please pay attention: Parts of the device will be subject to voltage, even if the mains switch has
been switched off. Pull the mains plug from the socket, to interrupt the power supply to your TFT
monitor or to release the device from voltage completely.
 Only operate the TFT monitor at an earthed socket with 100-240V~, 50/60 Hz. Ask your energy supplier if
you are not sure about the power supply at the set-up location.
 We recommend the use of protection against excess voltage for additional safety, in order to protect your
TFT monitor against damage because of voltage peaks or electrical flashes on the mains network.
 Pull the mains plug from the socket, in order to interrupt the power supply to your monitor.
 The socket must be located close to the TFT monitor and be easily accessible.
 Lay the cable so that no-one can tread on it or trip over it.
 Do not place any objects on the cable, because it could be damaged otherwise.
 Your device has an On/Off switch. The TFT monitor can be switched on and off by means of it. No power
will be consumed if the switch is standing at OFF (0). Put the On/Off switch to OFF or use a master/slave
power strip, in order to avoid power consumption when the device is switched off.
 Maintain at least one metre clearance from high frequency and magnetic sources of interference
(television device, loudspeakers, mobile phone, cell phone, etc.), in order to avoid disruptions to function
and data loss.
 The failure of individual or several scanning spots can arise in rare cases, in spite of the most modern
manufacture, because of the highly complex technology.
4
Safety information

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Md 20360

Inhoudsopgave