Inhoudsopgave
Advertenties
Device-specific additional instructions for nailer 3447-10
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Press the latch button 1 and push the magazine cover 2 to the
rear. Insert the shaft nails into the magazine 3 with the red side
facing upwards. Then push the magazine cover 2 forward.
5
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
Advertenties
Inhoudsopgave
