Inhoudsopgave
Advertenties
Assembly
Cutting tools can cause injuries.
- Always keep hands and feet away from the cutting tools, especially when turning on the
motor.
If necessary, apply a little bit of dishwashing detergent to the connector pins of the floor
and side parts
Assembling the product
To assemble the equipment box, proceed as follows:
1
3
1. Use a hole saw to drill the outlets for the lines into the side parts
are designed for a 45 mm or 75 mm hole saw.
2. Insert the bottom part
the individual parts. The inside of the bottom part points down.
3. Insert the two side parts into the front part. The recesses in the side parts are on the bottom.
4. Insert the back part into the bottom part and into the two side parts. This will require some force.
You will hear a dull sound when the back part snaps into place.
5. Put on the cover
6. Position the equipment box at the prepared setup location.
The equipment box is assembled.
Loading the equipment box
Observe the following when loading the equipment box:
- Read the operating instructions for the pool equipment before loading the equipment box.
- Guide the lines to the pool equipment through the recesses in both side parts.
The equipment box is loaded.
Cleaning
Only clean the product with a standard bathroom cleaner, clear tap water and a lint-free cloth.
Aggressive cleaning agents can damage the product. Dry the product with a lint-free cloth.
Risk of injury!
to make the assembly of your Steinbach pool equipment box easier.
3
into the front part
3
.
1
CAUTION!
2
1
2
3
3
3
. Pay attention to the positioning of the recesses in
2
5
2
4
1
. The predefined cutting guides
3
13
Advertenties
Hoofdstukken
Inhoudsopgave
