Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Frequently Asked Questions
Maximum interlinked detectors: 30 Aroha Link smoke, CO and combination detectors can be
interlinked in 1 group.
Detector sounds an alarm: The test mode is activated as the test button was not pressed
fast enough. After the alarm stops, try pressing the test button again 4 times as quickly as
possible within 1 second.
Connection fails: The green LED will continue to flash for 1 minute, followed by a red LED for 2
seconds to indicate that the connection was not successful. In that case, start the pairing
process again.
Test detectors: The detectors have a transmission range of 100 meters without obstructions,
such as walls, ceilings, doors and windows. After installation, you can test whether all
detectors are properly connected to each other by pressing the test button of 1 detector; then
all test alarms from all linked detectors will also sound.
Unlinking: Press the test button on the detector twice within 1 second and the green LED will
slowly flash for 60 seconds (receiving mode). After this period, it will stop flashing and the
alarm is unlinked.
C. Test your alarm
Test the detector to ensure proper operation by pressing the test button (= centre front of
detector). The alarm will sound if the detector is working well. If there is no sound, refer to the
"Trouble shooting" section. If there is no sound from the connected detectors, repeat the
interlinking-proces as discribed in chapter B.
CAUTION
DO NOT test your detector using an open flame. This may damage the detector or ignite
combustible materials and start a structural fire.
Test the detector at least once a month.
DO NOT stand close to the detector when the alarm is sounding. Exposure at close range may
be harmful to your ears.
EN
04
Advertenties
Inhoudsopgave
