Inhoudsopgave
Advertenties
11.2
Maintenance
NOTE
Before performing any maintenance or lubrication, disconnect the machine from the power
source.
1.
The table height adjustment screw shafts located at either end of the machine must be well
lubricated with grease.
2.
Make sure all nuts and screws are tight before sanding. Check that the sanding belt is
mounted properly, and have not become loose or torn.
Do not allow excessive dust to accumulate on or in the machine.
During cleaning and maintenance in machine connected:
Property damage and serious injury from inadvertent starting the machine!
Therefore:
Before maintenance, switch off the machine and Separate power supply
Disturbances or defects which can affect the security of the machine allow to immediately
remove.
The entire and regular cleaning of the machine guarantees a long life span and shows a
security condition. Use exclusively mild cleaning agents, i.e. no petrol, paraffin, soda etc.
...
Check regularly whether the warning tips and security tips are in the machine available
and in perfectly legible state
Check before every company the flawless state of the security facilities.
With storage of the machine this may not be kept in a humid space and must be protected
against the influence by weather terms.
Control all screw combinations on firm seat every week
Your specialist supplier does the removal of defects
Repair operations may be carried out only by specialist staff
12
RECYCLING
Do not dispose of your machine in residual waste. Contact your local authorities for
information on available disposal options. If you buy a new machine or equivalent
from your dealer, he is obliged in certain countries to dispose of your old machine
properly.
HOLZMANN MASCHINEN GmbH
A T T E N T I O N
www.holzmann-maschinen.at
RECYCLING
21
MTY 8-70
Advertenties
Inhoudsopgave
