Inhoudsopgave
Advertenties
4. ASSEMBLY
Step 1
Turn the main rail (40) over and secure the rear stand (55) with the screws (92), (Figure 1). Slide the
seat (44) into the main rail as indicated by the direction arrow (Figure 2). Then install the rail connec-
tor (37) with the perforated plate (100) and the pre-installed screws (54). The perforated plate can
only be attached in one direction: The side where the recess between the small hole and the edge of
the plate is larger must face the main rail. Fasten the stoppers (38) with the M8 nuts (7) and M8x25
screws (14).
92 92
100
EN
Step 2
Install the front stand (99) on the main frame (28) using the screws (54). Remove the handle (97),
washer (11) and locking pin (98) from the rail connector (37). Connect the main rail (40) to the
main frame (28) as indicated by the direction of the arrow. Fasten the main rail (40) with the screw
M8x130 (36), the washer (58), the nut M8 (7) and the nut sleeve (49). Re-insert the locking pin
(98) and secure the handle (97) with the washer (11) to the rail connector (37).
97
54
98
99
33
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
