Advertenties
Whether you select 1 or 3 or 6 , you may set each meal time at any time, by any portion. For
example: you select 3 meals/day (as breakfast + lunch + dinner), 6 portion each meal.
1. Setting the first meal (Breakfast)
After setting the desired number of meals to 3 also pressed [OK] to confirm. Now to set 1 meal.
HOUR, and MINUTE will flash. In sequences: set the Hour by pressing [UP] button. Press [OK]
once desired Hour is shown; set the Minute by pressing [UP] button. Press [OK] once desired
Minute is shown. Now set the Portion size by pressing [UP] button to the desired number of
meal. Press [OK] button to confirm. In this example, we would like to press [UP] button 6 times,
then press [OK] button.
2. Setting the second meal (Lunch):
After first meal is set; now to set 2 meal. HOUR, and MINUTE will flash. Set the Hour by
pressing the [UP] button until the desired Hour is shown. Press [OK] to confirm. Next, set the
Minute by pressing the [UP] button until the desired Minute is shown. Press [OK] to confirm.
Then set the portion. In this example, we would press [UP] button 6 times, and then press [OK]
button.
3. Setting the third meal (Dinner)
After second meal is set; now to set 3 meal. HOUR, and MINUTE will flash. Use the [UP] button
to set the Hour, press [OK] to confirm. Further use the [UP] button to set the Minute, press [OK]
to confirm. Finally, set the Portion by pressing [UP] button and press [OK] to complete the
settings, in this example, we would press [UP] button 6 times, press [OK]. Now the LCD display
stop flashing, set up is complete, automatically return to the Normal mode.
• Additional Feature: Feed your pet randomly at any time! NOTE: Beside the alrea`dy pre-set
daily meals, you may occasionally feed your pet at a preferred time (for example: in evening), by
pressing [UP] button.
Once you release these button, it stops feeding immediately. This additional function can be
used either to test function or to see performances in factory.
• Additional Feature: TOTAL NOTE: As you can see "TOTAL" on the LCD display. It is to show
the total number of meals the machine has served from start to the last meal. It is automatically
reckoned by the machine. This figure will return to zero (0) once you set the power switch off, or
reset the function.
Main purpose, for pet owner to calculate total of meals can be served for a full hopper. So she may
estimate how many days the machine can serve, in case she wants to travel away.
• Change The Batteries:
NOTE: Your programming information is stored and will not be lost when you switch
off or change the batteries. But you may re-set the new program at any time needed.
Just repeat the [Programming Your Pet Feeder]
• You need to replace the batteries when LCD display becomes vague. Or if the
automatic pet feeder was unattended for a long period of time.
• Repeat the above [Battery Installation] instruction to replace all new fresh
Advertenties
