Inhoudsopgave
Advertenties
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
5. Put the guard cap onto the guard.
6. Align the screw holes on the guard cap with the screw
holes on the guard.
7. Tighten the screws.
3.3
ASSEMBLE THE SHAFT
Figure 3.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the hex wrench.
3.4
ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Loosen the central knob.
2. Remove the cap and the lower support.
NOTE
Do not miss the spring in the support.
3. Put the auxiliary handle in the lower support.
4. Put the cap to the lower support.
5. Put the entire block in its housing on the shaft.
6. Set the auxiliary handle in the comfortable position.
7. Lock the auxiliary handle with the central knob.
3.5
INSTALL THE BATTERY PACK
Figure 5.
WARNING
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
English
3.6
REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1
START THE MACHINE
Figure 6.
1. Push the lock-out button and pull the trigger.
4.2
STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3
OPERATION TIPS
Figure 7.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
•
Keep the machine connected to the correctly worn
harness.
•
Keep a firm hold with two hands on the machine while
you operate the machine.
•
Cut tall grass from the top down.
If grass winds around the trimmer head:
•
Remove the battery pack.
•
Remove the grass.
4.4
CUTTING TIPS
Figure 8.
•
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
•
Move the machine from right to left to prevent thrown
debris toward the operator.
•
Do not cut in dangerous areas.
5
IMPORTANT
WARNING
WARNING
WARNING
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
