Inhoudsopgave
Advertenties
Warnings
• Use heat-protection/resistant gloves when operating the COBB® Pro Gas.
• The unit must be properly assembled according to the instructions. Do not use the COBB® Pro Gas unless all parts are in
place.
• The COBB® Pro Gas is a stand-alone unit and must not be built-in to any construction. Ignoring this could cause serious
damage/injury to property or the persons operating the unit. This also applies to installation in or on recreational vehicles/
caravans or boats.
• The COBB® Pro Gas is not intended for commercial use
• The COBB® Pro Gas is not intended for use as a heater, nor should it ever be used as a heater.
• The unit should not be used when under the influence of alcohol and/or any prescription/non-prescription drugs as this
impairs the ability to properly assemble and operate the unit.
• Do not alter any parts sealed by the manufacturer, any modifications could be dangerous and will void the warranty.
• Do not use the COBB® Pro Gas under an overhang or a combustible roof.
• Ensure that all electrical cables are kept away from the heated surfaces while in use.
• This appliance shall only be used in an above ground open air situation with natural ventilation, without stagnant areas,
where gas leakage and products of combustion are rapidly dispersed by wind and natural convection.
When using gas canisters
When using gas canisters – Model PROGA001 / 002
Model PROGA001 / 002 use Butane canister which complies with EN417 specifications from Europe.
Fitting the gas canister into the COBB® Pro Gas (Model PROGA001 / 002)
• Use outdoors only.
• If there is a leak on your appliance(smell of gas),take it outside immediately into a well ventilated flame free location, away
from people, where the leak may be detected and stopped.
• If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame, use soapy water.
• Check the seals before connecting a new gas container to the appliance.
• If you detect a smell of gas, ensure the regulator knob is in the off position. Unscrew the gas canister, turning the canister to
the left (anti clockwise) prior to reconnecting. Be certain the canister threads are not cross threaded and ensure that seal is
correctly seated. Do not use an open flame to check for leaks.
• Check that the regulator "O" ring is in place and not damaged. See Diagram A.
• Change the gas container outside and away from people.
• Do not incinerate or puncture the canister even if empty.
English
7
Advertenties
Inhoudsopgave
