Inhoudsopgave
Advertenties
It is necessary to specify safety meas-
ures for the protection of the user which
are based on the vibration load incurred
under conditions of real use (in doing
so, all elements of the operating cycle
are to be considered, for example, times
during which the power tool is switched
off, and those in which it is switched on
but operating without load).
Try to keep the load caused by vibration
and noise as low as possible. Examples
of measures that may be taken to
reduce the vibration load include wear-
ing gloves when using the tool, the
restriction of working times, and the use
of accessories that are in good condi-
tion.
3 – Components
1
Gear cover
2
On/Off switch
3
Stop button for continuous
operation
4
Impact rate regulation
5
Operating display
6
Additional handle
7
Tool holder
8
Flat chisel
9
Single-poined chisel
10
Flange wrench
4 – Correct use
Demolishing of masonry (fig. 7+8).
Use suitable accessories only (see man-
ufacturer's directions). All other applica-
tions are expressly excluded.
The tool is intended only for no industri-
al use.
This unit may not be used by peo-
36
ple (including children) with reduced
5452990-Abbruchhammer-man.indd 36
5452990-Abbruchhammer-man.indd 36
physical, sensory or mental capacities,
with a lack of experience and without
the appropriate knowledge, unless
they are supervised by someone who
is responsible for their safety or have
been instructed by such a person with
regard to how the unit is to be operated.
Children should be supervised to ensure
that they do not play with the device.
WARNING! The warranty is void-
ed by any improper use or use
not in accordance with manufactur-
er's instructions. Any necessary
repair must be performed by qualified
personal.
Improper use of the product
This power tool may not be used as a
screwdriver.
All applications carried out with the
device that are not listed in the "Correct
use" chapter will be considered improp-
er use.
Uses for which the tool is not designed
may cause risks and injury. Do not use
accessories that are not intended spe-
cifically for this electrical tool.
Just because you can affix an accessory
to your electrical tool, there is no guar-
antee it is safe to use.
The permitted revolutions of the tool
insert must be at least as high as the
highest value specified on the electrical
tool. Accessories that turn faster than is
permitted may break and fly away.
The external diameter and thickness
of the tool insert must match the dimen-
sions of your electrical tool. Incorrectly
measured tool inserts cannot be proper-
ly protected or checked.
01.09.21 09:19
01.09.21 09:19
Advertenties
Hoofdstukken
Inhoudsopgave
