Inhoudsopgave
Advertenties
Press once again to activate both Alarm 1 and 2. Both
Press once again to deactivate both alarms (both
TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
When alarm 1 or 2 is sounding, the related alarm icon flashes. Press AL1-2 /ON-OFF once to stop
the alarm and reset it to come on the following day. After that both
on the display.
TO ACTIVATE THE SNOOZE FUNCTION (default snooze duration is 5 minutes)
When alarm is sounding, press
on again after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
TO SET UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
TO LISTEN TO THE FM RADIO
To turn on the radio, press RADIO/SLEEP once, the display shows "ON" and then the radio
frequency readings in Mhz.
Press
or
the next clear station.
To adjust the volume, press VOL SET once, the display shows "L07", press
adjust volume from L01 (minimum) to L16 (maximum) .
Press RADIO/SLEEP to turn off the radio.
Note: keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
TO STORE FM RADIO STATIONS IN MEMORY
This clock radio features a total of 20 preset memories of FM stations. These allow you to preset your
favorite stations and access them quickly.
Press RADIO/SLEEP once to turn on the radio. Then tune to a FM radio station you like to
preset.
Press and hold the SET until "P01" flashes. Press SET once to store to "P01".
Press
or
Press and hold SET until "P02" flashes. Press
once to store to "P02".
Repeat Step 2 to 4 to store radio stations to P03 through P20.
To remove a pre-stored station, repeat steps 2 to 4 to store another station in its place.
to tune the radio to a desired station. Press and hold
to select another station you like to preset (the radio frequency is displayed).
LED and
LED and
once, the alarm will be silenced momentarily and come
once to select 'P02", then press SET
EN6
LED appear.
LED disappear).
LED and/or
LED remain
or
to scan for
or
to
Advertenties
Inhoudsopgave
